I. Introduction: stainless steel bright acid lotion KM0201 applicable 304,316 and other high-nickel stainless steel, to remove oxides, rust and spot welding surface, and can improve the gloss of the workpiece surface. By cleaning this product, can effectively ensure the cleaning process does not change the workpiece size, and greatly improve gloss stainless steel workpiece surface. Second, the use of materials: 304,316 other cleaning process is widely used in high-nickel stainless steel, especially for large area precision small complex parts cleaning process. Such as screws, axle pin, precision mechanical transmission parts, communications equipment and other fasteners, such as cleaning the light treatment. Third, the stainless steel pickling powerful advantage: ▲, pickling and degreasing function combo, decontamination, rust, spot welding, will not have material matrix cause corrosion; ▲, product color uniform after treatment, appearance agreement. Unity "silver"; low ▲, cost, liquid can be reused, high efficiency, is the best alternative to mechanical polishing or rust; simple ▲, operation, just to soak at room temperature; ▲, safety and environmental protection, Operating environment-friendly; ▲, does not affect the conductive properties of the material does not change the material composition, does not affect the spray-binding. Fourth, the operation process of the workpiece to be treated bright pickled --- --- --- bubble pure water over water --- drying or dry Note: the process can be adjusted according to the actual situation V. Notes * This product is dope use, the temperature can, rust and slight temperature oxidation Piga better to room temperature. · The workpiece surface clean and free of oil put this product at room temperature for 5-30 minutes later, rinse with water clean, rinse with water, then soaked in pure water and drying to packaging from 1 to 3 minutes. Sixth, the effect of post-treatment: ? You can keep the workpiece after the original color (true color), does not change the workpiece size, improve the surface quality. · Improve the corrosion resistance of stainless steel, the passive film breakdown potential than untreated may increase to about several hundred millivolts, and through provisions of national unity "blue point" test, 30 seconds without a blue dot.